103
Fig. 11.5.Template Details Tab
Next click on the Thickness Measurement Points tab. You
should see 8 measurement points called P1 to P8. Fig. 11.6 shows
the completed form, follow these steps:
1. Rename the 8 measurement point Names “NORTH TOP”,
“NORTH BOTTOM”, etc to match the spreadsheet names.
2. Enter the 8 Cell Ref. names so the measurement values will
be put in the correct place in the spreadsheet.
3. We want to alert the surveyor if any thickness measurement
is less than 4mm, so enter “4” for each Minimum value.
4. In this example there are no Reference thickness values
required so they are left at zero, but you could enter in
thickness values if you needed to.
To Next Page
Loading...