Cygnus 3 - Measurement Units Configuration

Cygnus 3 Operating Manual
M4-CYG3-M-ENG_Iss2.doc
28
Measurement Units
The Gauge can display thickness measurements in either Metric
(mm) or Imperial (inch). Changing the measurement units does
not affect the calibration.
When data logging you can’t change the measurement units.
1.
Press the MENU key to display
the MAIN MENU
2.
Scroll down to GAUGE SETUP
then press OK
3.
UNITS should be highlighted
4.
Press the EDIT key to change
the UNITS setting:
mm to inch
inch to mm
5.
The gauge will automatically go
back to the measuring screen.