Cygnus 3 Operating Manual
M4-CYG3-M-ENG_Iss2.doc
66
Enter in the number of additional
points required, from 4 to 12.
Then press OK
The gauge is ready to start
logging the additional thickness
values
Note the measurement point
names have suffix A, B, C etc.
Once all the additional points
have been logged a message
alerts the user
Adding a Comment while Data Logging
A text comment can be added to the current Record File. This
comment will be included in the report printout.
To add a comment the gauge
must be in logging mode
Select ADD COMMENT from the
To Next Page
Loading...