To Next Page

To Previous Page

7. SOFTWARE INSTALLATION

7.1 Installing the RS-232 Driver

Insert the provided driver CD into your CD-ROM drive, then execute

the FIDIBUS le. Follow the on screen instructions to complete the

installation.

Note: It is not necessary to install this application if users already have

existing RS-232 software installed on their computer.

7.2 Connecting the Hardware

Once the RS-232 driver is installed connect the device to a PC/Laptop

with a mini-USB to USB-A type cable.

Step 1:

Allow the computer to detect the device by following the “found new

hardware” window that will appear. After the hardware has been

successfully detected conrm the detection in Device Manager.

Once the device is successfully connected to the PC, the connection

will be conrmed by the 'Found New Hardware' notication in the

system tray at the bottom right of the screen, as shown in the following

image.

Questions and Answers:

Need help?

Do you have a question about the CYP CLUX-UCEC and is the answer not in the manual?

CYP CLUX-UCEC Specifications

General