10
6.5 OSD
INput format/OUTput Resolution
Firmware Information
PC Monitor Information
1. Press the button on the top panel once to switch in between CV/SV. If
the input source is disconnected the OSD will show “No Signal”.
2. Press and hold the button on the top panel for 3 seconds to bring up
OSD manual.
3. When the device is in 'PC mode' the OSD will display the input format
and output timing, source detection, PC monitor’s EDID and firmware
version as in the above picture.
4. When the device is in 'HD mode' the OSD will display input format
and output timing, frame rate conversion selection, video system and
firmware version as shown in below picture.
INput format/OUTput Resolution
Firmware Information
To Next Page
Loading...
