7
ACTION-215A
- 2-way powered system
- 2 x 15" bass loudspeaker
- Compression driver with titanium diaphragm
- Two steel-reinforced handles
The ACTION-215A is a powered loudspeaker (2 channel
Class D amplifier), that utilizes two 15” bass loudspeakers for
extra low frequency punch and higher SPL. High frequencies
are handled by a 1” compression driver with titanium
diaphragm. The trapezoidal cabinet is constructed using Birch
plywood and protected with a hard-wearing black paint finish.
Two bar handles and a steel grille sealed against corrosion
using a polyamide powder coat finish are provided. Rigging
points provide a safe and simple way to fly the ACTION-215A
cabinets.
ACTION-18A
- Bass-reflex powered subwoofer system
- 18" low frequency transducer
- Precise and powerful bass reproduction
- Top located pole mount socket
The ACTION-18A bass powered system (Class D amplifier)
incorporates a 18” low frequency transducer with a 4" voice
coil mounted as a direct radiator into a bass-reflex cabinet. The
loudspeaker is protected by a perforated steel grille, sealed
against corrosion using a powder coat finish. The ACTION-18A
is designed for use in biamped systems. A top located pole-
mount socket permits mounting full-range systems above the
ACTION-18A and two bar handles makes moving easy.
ACTION-218A
- High output bass-reflex powered subwoofer system
- Twin 18" loudspeakers
- Durable black paint finish
- Side located bar handles
This bass-reflex powered subwoofer system uses dual 18"
bass loudspeakers equipped with 4" voice coils. The
exceptional power handling capacity and efficiency provide high
sound pressure levels of powerful bass. Two hand locations
facilitate handling. The cabinet is designed to be stacked in the
vertical position in order to reduce the units "on-stage"
footprint.
ACTION-118A
- Powered horn-bass subwoofer system
- Class D 3200W amplifier
- 1x D.A.S. 18" long excursion woofer
- Deep/Loud EQ selector
- Filtered output defeat switch
- Variable 80-125 Hz high-pass filter
- Gain control and polarity switch
- Top located pole mount socket
The ACTION-118A horn bass powered system (Class D
amplifier) incorporates a 18” long excursion woofer with a 4"
voice coil mounted as a direct radiator with load cabinet. The
loudspeaker is protected by a perforated steel grille, sealed
against corrosion using a powder coat finish. The ACTION-118A
is designed for use in biamped systems. A top located pole-
mount socket permits mounting full-range systems above the
ACTION-118A and two bar handles makes moving easy.
Manual del Usuario / action series / User’s Manual
To Next Page
Loading...
