To Next PageTo Next Page
Need help?Do you have a question about the D.A.S. DSP-226 and is the answer not in the manual?
General| Maximum Input Level | +20 dBu |
|---|---|
| Maximum Output Level | +20 dBu |
| Dynamic Range | > 110 dB |
| Crossover Filters | Butterworth, Linkwitz-Riley, Bessel |
| EQ Filters | Parametric, Shelving, Notch |
| Output Impedance | 100 Ω |
| THD+N | <0.01% |
| Crossover Slopes | 12, 18, 24 dB/octave |
| Polarity | Normal / Invert |
| Display | LCD |
| Connectors | XLR |
| Frequency Response | 20 Hz - 20 kHz, ±0.5 dB |
Explains the functions of MUTE, PARAMETER encoder, and navigation buttons.
Covers how to navigate menus on the front panel.
Details on adjusting parameters for input and output channels.
Covers specific settings like Delay, PEQ, Compress, Link, Copy, Filter, Phase, Source.
How to load and save user and preset programs.
Procedures for deleting saved user programs from the device.
How to set device address and control lock/unlock functions.
How to connect a single unit to a PC for control via USB or RS485.
How to connect multiple units to a PC via RS485 for control.
Lists common operational issues and their corresponding solutions.
Refers to PC software instructions for interface operation.
How to reset the device to factory default settings.
