D.A.S. reference rf-12.85 User Manual

7
Rf-12.85 Rf-15.85 Rf-12.64
Figures show the block diagram and basic set-
up for models and
.
.
Rf-12.85 Rf-15.85 Rf-12.64,.
Passive (mono-amp) operation
Rf-215.85
Figures show the block diagram and basic set-
up for model
Figures show the block diagram and basic set-
up for model A switch, located at the
input connector plate, allows to change between
passive (full-range) and bi-amplified use. In passive
use, the acoustical high frequency roll off of the
low frequency section is used to crossover to the
mid/high frequency section, which utilizes an
equalized highpass filter network.
Rf-215.85
Rf-15.64
Passive (mono-amp) operation
Rf-15.64
When using the system in active (bi-amplified)
mode, use the D.A.S. electronic
processor or a 24 dB/octave electronic crossover
unit with the crossover frequency set to 1800 Hz.
Figures show the block diagram and basic set-
up. A switch located at the input connector plate,
allows to change between passive (full-range) and
bi-amplified use. In passive use, the acoustical
high frequency roll off of the low frequency section
is used to crossover to the mid/high frequency
section, which utilizes an equalized highpass filter
network.
When using the system in active (bi-amplified)
mode, use the D.A.S. electronic processor
or a 24 dB/octave electronic crossover unit with
the crossover frequency set to 1200 Hz.
DSP-26
DSP-26
Passive (mono-amp) operation
Active (bi-amp) operation
Rf-215.96
"BASS"
"HIGH"
(+1, -1)(+1, -1)
+1
-1
+2
-2
+1
-1
+2
-2
+1
-1
+2
-2
(+1, -1)(+1, -1)
X-over
(+2, -2)
(+2, -2)
(+1, -1)(+1, -1)
"BASS"
"HIGH"
"BASS"
"HIGH"
(+1, -1)(+1, -1)
+1
-1
+2
-2
+1
-1
+2
-2
"BASS"
"HIGH"
+1
-1
+2
-2
(+1, -1)(+1, -1)
Passive (mono-amp) operation
"BASS"
"HIGH"
EN
Manual del Usuario /r /User’s Manualeference

D.A.S. reference rf-12.85 Specifications

General

Brand	D.A.S.
Model	reference rf-12.85
Category	Speakers
Language	English