D-Link DCS-5300 Quick Installation Guide

2
Hardware Installation
System Requirements
• Internet Explorer 5.x or above
• CPU: Pentium III, 800 MHz or above (Required for use with IP surveillance software)
• Memory Size: 128 MB (256 MB recommended)
• VGA card resolution: 800x600 or above
Note: If using multiple cameras for viewing/recording, the minimum requirements
are a Pentium 4 (2GHz or above) CPU with 512MB memory and a 32MB video card.
Connect the Ethernet Cable
Connect an Ethernet cable to the Ethernet connector located
on the Internet Camera’s back panel and attach it to the
network.
Attach the External Power Supply
Attach the external power supply to the DC power input
connector located on the Internet Camera’s back panel
(labeled DC 12V) and connect it to an AC power outlet.
Both the red and green LEDs will flash alternately and only the red LED will remain lit.
The the green LED will not come on until you have configured your camera.
If you connect this camera directly to a
PC, you will need a cross-over Ethernet
cable. If you plug the camera into a hub
or router, you will be able to use the cable included
with your camera.
Power source is confirmed when
the LED Power Indicator on the
Internet Camera is illuminated.

D-Link DCS-5300 Specifications

General

Digital zoom	4 x
Maximum frame rate	30 fps
Camera shutter speed	1/60 - 1/15000 s
Minimum illumination	1 lx
Maximum video resolution	320 x 240 pixels
Pan range	270 °
Sensor type	CCD
Product color	Silver
Tilt angle range	-90 - 90 °
Built-in microphone	Yes
Optical sensor size	1/4 \
Focus	2.0
I/O ports	A/V MIC
Power supply type	12VDC 1.5A
Cabling technology	10BaseT, 100BaseT
Supported network protocols	TCP/IP, HTTP, SMTP, FTP, Telnet, NTP, DNS, DHCP
Compatible operating systems	Microsoft Windows XP, 2000, Me, 98SE
Dimensions (W x D x H) (imperial)	4.1 x 4 x 4.4 \
Minimum system requirements	Internet Explorer 5.x +