5
Configuring your camera with IP
Installer (continued)
Highlight the MAC address
This page will now show the IP Address
assigned to the MAC address of the
DCS-5300.
Click on the Link button
The IP Installer will now show the MAC
address of the DCS-5300 and an IP
Address (which may or may not be
correct depending on what you have
your DCS-5300 connected to.) If you
have a DHCP server on your network,
there will be a valid IP Address
displayed here. After a few seconds,
the “assigned” column will display yes,
indicating that the displayed IP Address
is now assigned to the camera.
If the IP Installer does not display any
devices, you will need to find a tool
small enough to fit into the reset hole
and softly press down a switch for 2
cycles (the red and green LEDs will
blink continuously and stop twice). Let
go when the red LED starts to flash
the second time.
To Next Page
Loading...
