Do not overtighten the screws as this may crack the bracket.
Mount the Camera
Please refer to the steps below to assist you with mounting the camera.
We suggest that you congure the camera before mounting.
• Place the wall mount where you want to
position the camera and use a pencil to
mark the holes.
• Use a 6mm drill bit to drill both holes at
least 30mm deep.
• Use a mallet to insert the wall anchors into
the holes.
• Place the mounting base over the holes
that are in the wall.
• Make sure to align the mounting base
holes with the holes in the wall and then
use the supplied screws to attach the
mounting base to the surface of the wall.
Warning: Placing your camera around water may cause accidental shocks.
• Place the base cover over the mounting
base and screw the camera stem into the
mounting base.
7
To Next Page
Loading...
Need help?
General
