DES-3028 DES-3028P DES-3052 DES-3052P Layer 2 Fast Ethernet Managed Switch
between the three Access Profile Configuration windows by using the Type drop-down menu. The window shown below is the
Access Profile Configuration window for Ethernet.
Note: The Profile ID is used for relative priority for an Access Profile should a conflict arise between
a rule created in one profile and a rule created in a different profile. Please read the CLI Reference
Manual chapter discussing Access Control List (ACL) Commands.
Figure 9- 3. Access Profile Configuration window (Ethernet)
The following parameters can be set, for the Ethernet type:
Parameter Description
Profile ID (1-256)
Type in a unique identifier number for this profile set. The number is used to set the relative
priority for the profile. Priority is set relative to other profiles where the lowest profile ID has
the highest priority. If a conflict occurs among configured access rules, the profile ID
establishes relative priority of the rules. The value can be set from 1 to 256 however there is
a limit to the total number of profiles that can be created.
Type
Select profile based on Ethernet (MAC Address), IP address or packet content mask. This
will change the menu according to the requirements for the type of profile.
•
•
•
Select Ethernet to instruct the Switch to examine the layer 2 part of each packet
header.
Select IP to instruct the Switch to examine the IP address in each frame's
header.
Select Packet Content Mask to specify a mask to hide the content of the packet
header.
VLAN
Selecting this option instructs the Switch to examine the VLAN identifier of each packet
header and use this as the full or partial criterion for forwarding.
Source MAC
Enter a MAC address mask for the source MAC address.
Destination MAC
Enter a MAC address mask for the destination MAC address.
802.1p
Selecting this option instructs the Switch to examine the 802.1p priority value of each packet
header and use this as the, or part of the criterion for forwarding.
Ethernet Type
Selecting this option instructs the Switch to examine the Ethernet type value in each frame's
header.
The window shown below is the Access Profile Configuration window for IP.
113
To Next Page
Loading...
