DES-3526 Layer 2 Fast Ethernet Switch
config access_profile
apply to only this VLAN.
• source_ip <ipaddr> − Specifies that the access profile will
apply to only packets with this source IP address.
• destination_id <value 0-255> − Specifies that the access
profile will apply to only packets with this destination IP
address.
• dscp <value 0-63> − Specifies that the access profile will apply
only to packets that have this value in their Type-of-Service
(DiffServ code point, DSCP) field in their IP packet header.
• priority <value 0-7> − Specifies that the access profile will
apply to packets that contain this value in their 802.1p priority
field of their header.
• dscp <value 0-63> − Allows you to specify a value to be written
to the DSCP field of an incoming packet.
• icmp − Specifies that the Switch will examine the Internet
Control Message Protocol (ICMP) field within each packet.
• type <value 0-65535> − Specifies that the access profile will
apply to this ICMP type value.
• code <value 0-255> − Specifies that the access profile will
apply to this ICMP code.
• igmp − Specifies that the Switch will examine the Internet
Group Management Protocol (IGMP) field within each packet.
• type <value 0-255> − Specifies that the access profile will
apply to packets that have this IGMP type value.
• tcp − Specifies that the Switch will examine the Transmission
Control Protocol (TCP) field within each packet.
• src_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this TCP source port in
their TCP header.
• dst_port <value 0-65535> − Specifies that the access profile
will apply only to packets that have this TCP destination port in
their TCP header.
• flag_mask – Enter the type of TCP flag to be masked. The
choices are:
• all: all flags are selected.
• urg: TCP control flag (urgent)
• ack: TCP control flag (acknowledgement)
• psh: TCP control flag (push)
154
To Next Page
Loading...
