DES-3526 Layer 2 Fast Ethernet Switch
26
MAC NOTIFICATION COMMANDS
The MAC notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their
appropriate parameters.
Command Parameters
disable mac_notification
config mac_notification {interval <int 1-2147483647> | historysize <int 1-500>
config mac_notification
ports
[<portlist> | all] [enable | disable]
show mac_notification
show mac_notification
ports
enable mac_notification
<portlist>
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose Used to enable global MAC address table notification on the
Switch.
enable mac_notification
Description This command is used to enable MAC address notification without
changing configuration.
Parameters None.
Restrictions
Syntax
Only administrator-level users can issue this command.
Example Usage:
To enable MAC notification without changing basic configuration:
DES-3526:4#
DES-3526:4#enable mac_notification
Command: enable mac_notification
Success.
disable mac_notification
Purpose Used to disable global MAC address table notification on the Switch.
disable mac_notification
Syntax
173
To Next Page
Loading...
