D-Link DES-3526 - Page 169

DES-3526 Layer 2 Fast Ethernet Switch
config sntp
service must be enabled for this command to function (enable sntp).
Example usage:
To configure SNTP settings:
DES-3526:4#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval
30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DES-3526:4#
show sntp
Purpose Used to display the SNTP information.
Syntax
show sntp
Description This command will display SNTP settings information including the
source IP address, time and poll interval.
Restrictions Only administrator-level users can issue this command.
Parameters None.
Example usage:
To display SNTP configuration information:
DES-3526:4#show sntp
Command: show sntp
Current Time Source : System Clock
SNTP : Disabled
SNTP Primary Server : 10.1.1.1
SNTP Secondary Server : 10.1.1.2
SNTP Poll Interval : 30 sec
DES-3526:4#
enable sntp
Purpose To enable SNTP server support.
Syntax
enable sntp
161