DES-3526 Layer 2 Fast Ethernet Switch
config time
Description This will configure the system time and date settings. These will be
overridden if SNTP is configured and enabled.
time – Express the system time using the format hh:mm:ss, that is,
two numerical characters each for the hour using a 24-hour clock,
the minute and second. For example: 19:42:30.
Restrictions Only administrator-level users can issue this command. Manually
configured system time and date settings are overridden if SNTP
support is enabled.
Parameters date – Express the date using two numerical characters for the day
of the month, three alphabetical characters for the name of the
month, and four numerical characters for the year. For example:
03aug2003.
Example usage:
To manually set system time and date settings:
DES-3526:4#config time 30jun2003 16:30:30
Command: config time 30jun2003 16:30:30
Success.
DES-3526:4#
config time_zone
Purpose Used to determine the time zone used in order to adjust the system
clock.
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
This will adjust system clock settings according to the time zone.
Time zone settings will adjust SNTP information accordingly.
operator – Choose to add (+) or subtract (-) time to adjust for time
zone relative to GMT.
hour – Select the number of hours different from GMT.
Restrictions Only administrator-level users can issue this command.
Syntax
Description
Parameters
min – Select the number of minutes difference added or subtracted
to adjust the time zone.
Example usage:
To configure time zone settings:
163
To Next Page
Loading...
