DES-3526 Layer 2 Fast Ethernet Switch
config dst
begins expressed using a three character abbreviation
(sun, mon, tue, wed, thu, fri, sat)
e_day - Configure the day of the week in which DST ends.
s_mth - Configure the month in which DST begins.
e_mth - Configure the month in which DST ends.
s_time – Configure the time of day to begin DST.
e_time - Configure the time of day to end DST.
s_date - Configure the specific date (day of the month) to begin
DST.
Restrictions
•
•
•
•
•
•
e_date - Configure the specific date (day of the month) to begin
DST.
•
offset [30 | 60 | 90 | 120] - Indicates number of minutes to add or to
subtract during the summertime. The possible offset times are
30,60,90,120. The default value is 60
<end_day sun-sat> - The day of the week in which DST
ends expressed using a three character abbreviation
(sun, mon, tue, wed, thu, fri, sat)
<start_mth 1-12> - The month to begin DST expressed as
a number.
<end_mth 1-12> - The month to end DST expressed as a
number.
<start_time hh:mm> - Time is expressed using a 24-hour
clock, in hours and minutes.
<end_time hh:mm> - Time is expressed using a 24-hour
clock, in hours and minutes.
<start_date 1-31> - The start date is expressed
numerically.
<end_date 1-31> - The end date is expressed
numerically.
Only administrator-level users can issue this command.
Example usage:
To configure daylight savings time on the Switch:
165
To Next Page
Loading...
