DES-3526 Layer 2 Fast Ethernet Switch
config arpentry
Description This command is used to configure a static entry in the ARP Table.
The user may specify the IP address and the corresponding MAC
address of an entry in the Switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address
above.
Restrictions Only administrator-level users can issue this command.
Example Usage:
To configure a static arp entry for the IP address 10.48.74.12 and MAC address 00:50:BA:00:07:36:
DES-3526:4#config arpentry 10.48.74.12 00-50-BA-00-07-36
Command: config arpentry 10.48.74.12 00-50-BA-00-07-36
Success.
DES-3526:4#
delete arpentry
Purpose Used to delete a static entry into the ARP table.
Syntax
delete arpentry {[<ipaddr> | all]}
Description This command is used to delete a static ARP entry, made using the
create arpentry command above, by specifying either the IP address
of the entry or all. Specifying all clears the Switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
all − Deletes all ARP entries.
Only administrator-level users can issue this command. Restrictions
Example Usage:
To delete an entry of IP address 10.48.74.121 from the ARP table:
DES-3526:4#delete arpentry 10.48.74.121
Command: delete arpentry 10.48.74.121
Success.
DES-3526:4#
168
To Next Page
Loading...
