D-Link DES-3526 - Section 9 Maintenance; TFTP Services

DES-3526 Layer 2 Fast Ethernet Switch
NOTE: TACACS, XTACACS and TACACS+ are separate entities and are not
compatible. The Switch and the server must be configured exactly the same, using
the same protocol. (For example, if the Switch is set up for TACACS
authentication, so must be the host server.)
The Access Authentication Control commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
enable
authen_policy
disable
authen_policy
show authen_policy
create authen_login
method_list_name
<string 15>
config authen_login [default | method_list_name <string 15>] method {tacacs | xtacacs |
tacacs+ | radius | server_group <string 15> | local | none}
delete authen_login
method_list_name
<string 15>
show authen_login {default | method_list_name <string 15> | all}
create
authen_enable
method_list_name
<string 15>
config
authen_enable
[default | method_list_name <string 15>] method {tacacs | xtacacs |
tacacs+ | radius | server_group <string 15> | local_enable | none}
delete
authen_enable
method_list_name
<string 15>
show
authen_enable
[default | method_list_name <string 15> | all]
config authen
application
{console | telnet | ssh | http | all] [login | enable] [default |
method_list_name <string 15>]
show authen
application
create authen
server_group
<string 15>
config authen
server_group
[tacacs | xtacacs | tacacs+ | radius | <string 15>] [add | delete]
server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
delete authen
server_group
<string 15>
show authen
server_group
<string 15>
create authen
server_host
<ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius] {port <int 1-
65535> | key [<key_string 254> | none] | timeout <int 1-255> |
retransmit <int 1-255>}
179