DES-3526 Layer 2 Fast Ethernet Switch
create authen server_host
Parameters server_host <ipaddr> - The IP address of the remote server host to
add.
protocol – The protocol used by the server host. The user may
choose one of the following:
port <int 1-65535> - Enter a number between 1 and 65535 to define
the virtual port number of the authentication protocol on a server
host. The default port number is 49 for
TACACS/XTACACS/TACACS+ servers and 1812 and 1813 for
RADIUS servers but the user may set a unique port number for
higher security.
key <key_string 254> - Authentication key to be shared with a
configured TACACS+ or RADIUS server only. Specify an
alphanumeric string up to 254 characters.
timeout <int 1-255> - Enter the time in seconds the Switch will wait
for the server host to reply to an authentication request. The default
value is 5 seconds.
retransmit <int 1-255> - Enter the value in the retransmit field to
change how many times the device will resend an authentication
request when the server does not respond.
Restrictions Only administrator-level users can issue this command.
tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes
the TACACS+ protocol.
radius - Enter this parameter if the server host utilizes the
RADIUS protocol.
Example usage:
To create a TACACS+ authentication server host, with port number 1234, a timeout value of 10 seconds and a
retransmit count of 5.
DES-3526:4#create authen server_host 10.1.1.121 protocol tacacs+ port
1234 timeout 10 retransmit 5
Command: create authen server_host 10.1.1.121 protocol tacacs+ port
1234 timeout 10 retransmit 5
Success.
DES-3526:4#
193
To Next Page
Loading...
