DES-3526 Layer 2 Fast Ethernet Switch
config authen server_host
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure a TACACS+ authentication server host, with port number 4321, a timeout value of 12 seconds and a
retransmit count of 4.
DES-3526:4#config authen server_host 10.1.1.121 protocol tacacs+
port 4321 timeout 12 retransmit 4
Command: config authen server_host 10.1.1.121 protocol tacacs+ port
4321 timeout 12 retransmit 4
Success.
DES-3526:4#
delete authen server_host
Purpose Used to delete a user-defined authentication server host.
Syntax
delete authen server_host <ipaddr> protocol [tacacs | xtacacs |
tacacs+ | radius]
Description This command is used to delete a user-defined authentication
server host previously created on the Switch.
Parameters server_host <ipaddr> - The IP address of the remote server host to
be deleted.
protocol – The protocol used by the server host the user wishes to
delete. The user may choose one of the following:
Only administrator-level users can issue this command.
tacacs – Enter this parameter if the server host utilizes the
TACACS protocol.
tacacs+ - Enter this parameter if the server host utilizes
the TACACS+ protocol.
xtacacs - Enter this parameter if the server host utilizes the
XTACACS protocol.
radius - Enter this parameter if the server host utilizes the
RADIUS protocol.
Restrictions
Example usage:
Command: delete authen server_host 10.1.1.121 protocol tacacs+
To delete a user-defined TACACS+ authentication server host:
DES-3526:4#delete authen server_host 10.1.1.121 protocol tacacs+
195
To Next Page
Loading...
