D-Link DES-3526 - Page 240

DES-3526 Layer 2 Fast Ethernet Switch
31
COMMAND HISTORY LIST
The switch history commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
?
dir
config
command_history
<value 1-40>
show
command_history
Each command is listed, in detail, in the following sections.
?
Purpose Used to display all commands in the Command Line Interface
(CLI).
Syntax
?
Description This command will display all of the commands available through
the Command Line Interface (CLI).
Parameters None.
Restrictions None.
Example usage
To display all of the commands in the CLI:
DES-3526:4#?
..
?
clear
clear arptable
clear counters
clear fdb
clear log
clear port_security_entry port
config 802.1p default_priority
config 802.1p user_priority
config 802.1x auth_mode
config 802.1x auth_parameter ports
config 802.1x auth_protocol
232