DES-3526 Layer 2 Fast Ethernet Switch
DES-3526:4#show serial_port
Command: show serial_port
Baud Rate : 9600
Data Bits : 8
Parity Bits : None
Stop Bits : 1
Auto-Logout : 10 mins
DES-3526:4#
config serial_port
Purpose
Used to configure the serial port.
Syntax config serial_port {baud_rate [9600 | 19200 | 38400 | 115200] |
auto_logout [never | 2_minutes | 5_minutes | 10_minutes |
15_minutes]}
Description
This command is used to configure the serial port’s baud rate and auto
logout settings.
Parameters
baud_rate [9600 | 19200 | 38400 | 115200]− The serial bit rate that will be
used to communicate with the management host. There are four options:
9600, 19200, 38400, 115200.
never − No time limit on the length of time the console can be open with
no user input.
2_minutes − The console will log out the current user if there is no user
input for 2 minutes.
5_minutes − The console will log out the current user if there is no user
input for 5 minutes.
10_minutes − The console will log out the current user if there is no user
input for 10 minutes.
15_minutes − The console will log out the current user if there is no user
input for 15 minutes.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure baud rate:
17
To Next Page
Loading...
