fis init
ip_address -h 192.168.1.2
load -r -b 0x80041000 linux.bin
fis create linux
fconfig boot_script true
fconfig boot_script_timeout 5
now type fconfig again and configure the bootscript to:
fis load -l linux
exec
and press enter for every other option to confirm the defaults.
Now type reset again. The unit should now boot dd-wrt and work as known from other atheros based
platforms
You are done now. Wait for your router to reboot. It will take about 1-2 minutes. It may blink and reset once
or twice (as noted).
Now open a Browser and connect to address 192.168.1.1 you should be able to see the dd-wrt page.
That's All
Recovery and Upgrade
connect to the bootloader with telnet on port 9000 and ip 192.168.1.1
do the following: (consider that fis create operations are taking sometimes several minutes to finish)
fis init -f
now load the latest linux.bin from your tftp-server:
ip_address -h 192.168.1.2
load -r -b 0x80041000 linux.bin
fis create linux
Redboot access script for Windows
Make a folder and download putty.exe to it
create a file in the same folder called redboot.txt, with the following content:
^C
create a file in the same folder called redboot.bat with the following content:
rem echo off
:start
rem ------------------------------------------------
ping 192.168.20.81 -n 1 -w 1 >NUL
IF ERRORLEVEL 1 goto start
D-Link_DIR-300_rev_A
Install DD-WRT 3
To Next Page