D-Link Technical Support – Applying WPA-PSK Encryption on the DIR-300. Page 2 of 3
1. First you will need a computer/laptop to be connected to one of the LAN Ethernet ports.
NOTE: If you are going to change your Wireless Encryption, DO NOT perform this over a
Wireless connection, connect your computer/laptop to a LAN Port.
2. Proceed to open an Internet Browser and login to the DIR-300 Web Configuration.
NOTE: Instructions are on the Technical Support Knowledge Base if you are unsure on
how to login to the Web Configuration.
3. Click on SETUP > Wireless Setup > Manual Wireless Connection Setup button.
4. Once you have access to the Wireless Setup page, there are only a couple of
adjustments needed to be made, please see below:
To Next Page
Loading...
