D-Link DIR-300 - Page 3

D-Link Technical Support – Applying WPA-PSK Encryption on the DIR-300. Page 3 of 3
It is recommended to change the Wireless Network Name (SSID) to a name of your liking,
in this example it is called "home_network". Enable Auto Channel Selection can be
enabled however it is not mandatory. The Wireless Channel can be changed, Channel's 1,
6 and 11 are non overlapping and are recommended.
Under the WIRELESS SECURITY MODE heading select from the dropdown "Enable
WPA Only Wireless Security (enhanced)".
Under the WPA ONLY heading the Cipher Type and PSK/EAP settings are recommended
on their default setting. The Network Key is where you type in a password for your
Wireless, it can be alphanumeric and a minimum of 8 characters. The Network Key is
considered to be your Wireless Password. REMEMBER IT!
5. Now proceed to click on the Save Settings button.
6. WPA-PSK Encryption is now configured.
IMPORTANT:
If you decide to change your Wireless Encryption password, you will need to remove
your existing Wireless Profile or edit it to reflect the new changes.
Please remember to ensure your DIR-300 has the most current firmware version
applied. To apply this firmware please refer to the Technical Support Knowledge
Base.