D-Link DIR-X5460 User Manual

1
T
echnical Support Setup
Procedure
DIR-X5460 Initial Setup using Web Configuration page
Step 1: Connect the two antennas to its corresponding connectors on the router.
Step 2: Power off the modem.
Step 3: Connect the Ethernet cable from the internet port of the router and the other end to the
modem.

D-Link DIR-X5460 Specifications

General

DSL WAN	-
Ethernet WAN	Yes
SIM card slot	No
Frequency range	2.4 - 5 GHz
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11ax, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3ab, IEEE 802.3az, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Ethernet interface type	Gigabit Ethernet
USB ports quantity	2
Ethernet LAN (RJ-45) ports	4
Security algorithms	128-bit AES, WPS
Flash memory	128 MB
Certification	FCC, IC, NCC, CE, RCM
Internal memory	512 MB
Minimum system requirements	Windows 10/8.1/8/7/Vista or MAC OS X 10.6 or higher Supports Internet Explorer 10, Firefox 28.0, Chrome 28.0, Safari 6.0, and up Network Interface Card Cable/DSL modem or other Internet service provider equipment with Ethernet port
Mac operating systems supported	Mac OS X 10.6 Snow Leopard, Mac OS X 10.7 Lion, Mac OS X 10.8 Mountain Lion, Mac OS X 10.9 Mavericks
Windows operating systems supported	Windows 10, Windows 7, Windows 8, Windows 8.1, Windows Vista
Product color	Black
LED indicators	Network, Power, USB
Output current	2 A
Output voltage	12 V
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Storage temperature (T-T)	-20 - 65 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Harmonized System (HS) code	85176990

Weight and Dimensions

Depth	338.8 mm
Width	241.35 mm
Height	211.32 mm
Weight	732 g

Summary

DIR-X5460 Initial Setup

Connect Router Antennas

Connect the two antennas to their corresponding connectors on the router by twisting them clockwise.

Power Off Modem

Unplug your DSL or cable modem and remove its battery backup, if applicable.

Connect Modem to Router

Plug one end of an Ethernet cable into the router's INTERNET port and the other end into your modem.

Router Power Up and Access

Power On Devices and Access Router

Power on modem, then router. Connect computer via LAN/Wi-Fi and access router's web interface.

Initial Router Configuration Steps

Login and Start Setup

Log in using the device password and click 'Next' to begin the setup wizard.

Select Internet Service Provider

Choose your Internet Service Provider from the list or select 'Others'.

Configure Internet Connection

Wait for connection detection and select the required connection type (DHCP, PPPoE, Static IP).

Set Wi-Fi and Admin Credentials

Enter Wi-Fi network name/password and create a strong admin password for router security.

Configure Time Zone and Updates

Select your time zone and choose automatic updates for the device.

Review and Save Settings

Review the summary of your settings and click 'Next' to save the configuration.