3
Installing the DKVM-2KU
Attach the DKVM-2KU‘s built-in
monitor cable to the VGA port
located on the back of your
computer case.
Attach the DKVM-2KU’s built-in
mouse cable to the PS/2 mouse
port located on the back of your
computer case.
Attach the DKVM-2KU’s built-in
keyboard cable to the PS/2
keyboard port located on the
back of your computer case.
Type A
Power ON all your attached computers after you have
completed the DKVM-2KU installation.
The following steps below apply to both the computers that you are using with your
DKVM-2KU.
Note:
In case you’d like to share USB
device(s), attach your USB Hub
or device’s (USB A type
connector) to the console port of
the DKVM-2KU. After that, attach
the DKVM-2KU‘s built-in USB
cable to the USB port located on
the back of your computer case.
To Next Page
Loading...
