Need help?Do you have a question about the D-Link DES-105 and is the answer not in the manual?
General| MAC address table | 2000 entries |
|---|---|
| Jumbo frames support | Yes |
| Packet buffer memory | 0.384 MB |
| Maximum data transfer rate | 0.1 Gbit/s |
| Supported data transfer rates | 10/100 Mbps |
| 10G support | - |
| Networking standards | IEEE 802.1p, IEEE 802.3, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x |
| Copper ethernet cabling technology | 100BASE-TX, 10BASE-T |
| Dimensions (WxDxH) | 100 x 98 x 28 mm |
| Connectivity technology | Wired |
| Switch type | Unmanaged |
| Power connector | DC-in jack |
| Basic switching RJ-45 Ethernet ports quantity | 5 |
| Certification | RoHS, FCC Class B, ICES-003 Class B, CE Class B, C-Tick Class B, VCCI Class B, cUL, CB |
| Product color | Black |
| Rack mounting | No |
| LED indicators | Link, Power, Y |
| Housing material | Metal |
| Input current | 1 A |
| Input voltage | 5 V |
| Power consumption (typical) | 3.10 W |
| Mean time between failures (MTBF) | 495709 h |
| Storage temperature (T-T) | -10 - 70 °C |
| Operating temperature (T-T) | 0 - 50 °C |
| Storage relative humidity (H-H) | 5 - 90 % |
| Operating relative humidity (H-H) | 10 - 90 % |
Weight and Dimensions| Depth | 98 mm |
|---|---|
| Width | 100 mm |
| Height | 28 mm |
| Weight | 265 g |
This manual will familiarize you with the DES-105/108 and guide you through the installation process.
Explains Fast Ethernet technology, its standards, and benefits for network upgrades.
Describes switching technology as a solution for network congestion and capacity increase.
Details the switch's support for 802.1p priority queuing and Quality of Service.
Instructions for unpacking the switch and verifying package contents.
Steps for physically setting up the switch, including power and ventilation.
Details the components and LEDs found on the front panel of the switch.
Details the power jack and security slot on the rear panel of the switch.
Guide on connecting a computer to the DES-105/108 switch.
Instructions for connecting a hub to the DES-105/108 switch.
Procedure for connecting the switch to other network devices.
Explains the auto-negotiation process for port speed and duplex mode.
Steps for mounting the switch on a cement wall using anchors and screws.
Steps for mounting the switch on a wood wall using screws.
Instructions for mounting the switch on a metal surface using magnetic base screws.
General technical specifications including standards, protocol, data transfer, topology, and ports.
Physical and environmental specifications: DC inputs, power, temperature, humidity, dimensions, EMI, safety.
Performance specifications: transmission method, RAM buffer, filtering table, forwarding rate, MAC learning.
To Next Page
