802.11 a/g Dual Band Access Point Command Line Interface Manual
7
3
CLI
C
OMMANDS
The following is a complete list of the Command Line Interface (CLI) commands along with their respective arguments.
Access Point CLI command
Function Syntax
Config Commands:
config wlan
Select WLAN Adapter to configure. Only WLAN 1 is available for
configuration. This command is not necessary.
config wlan [0:1]
Delete Commands:
del acl Delete specified Access Control List entry del acl [1-16]
del wdsacl Delete specified WDS ACL entry: 1-8 del wdsacl [1-8]
del key Delete specified Encryption key del key [1-4]
DHCP Server Help Command:
dhcps help Display DHCP Server Command Help dhcps help
dhcps state get DHCP Server state dhcps state
dhcps state <on|off> set to on or off DHCP Server dhcps state [on|off]
dhcps dynamic info get current settings dhcps dynamic info
dhcps dynamic ip set start ip dhcps dynamic ip <x.x.x.x>
dhcps dynamic mask set netmask dhcps dynamic mask <x.x.x.x>
dhcps dynamic gw set gateway dhcps dynamic gw <x.x.x.x.>
dhcps dynamic dns set dns dhcps dynamic dns <x.x.x.x>
dhcps dynamic wins set wins dhcps dynamic wins <x.x.x.x>
dhcps dynamic range set range dhcps dynamic range [0-255]
dhcps dynamic lease set lease time (sec.) dhcps dynamic lease [60-31536000]
dhcps dynamic domain set domain name dhcps dynamic domain <string..>
dhcps dynamic state set state dhcps dynamic state [on:off]
dhcps dynamic map get mapping list dhcps dynamic map
dhcps static info get setting from <0-255> to <0-255> dhcps static info [0-255] [0-255]
dhcps static ip set static <id> pool start ip dhcps static <id> ip <x.x.x.x>
dhcps static mask set static <id> pool netmask dhcps static <id> mask <x.x.x.x>
dhcps static gw set static <id> pool gateway dhcps static <id> gw <x.x.x.x.>
To Next Page
Loading...
