30D-Link DIR-628 User Manual
Section 3 - Configuration
The Auto Channel Scan setting can be selected to allow the DIR-628 to choose the channel with the least amount of
interference.
Indicates the channel setting for the DIR-628. By default the channel is set to 6. The Channel can be changed to fit the
channel setting for an existing wireless network or to customize the wireless network. If you enable Auto Channel Scan,
this option will be greyed out.
Select the transmit rate. It is strongly suggested to select Best (Auto) for best performance.
Select the Channel Width:
Auto 20/40 - Select if you are using both 802.11n and non-802.11n wireless devices.
20MHz - Select if you are not using any 802.11n wireless clients. This is the default setting.
Select Invisible if you do not want the SSID of your wireless network to be broadcasted by the DIR-628. If Invisible is
selected, the SSID of the DIR-628 will not be seen by Site Survey utilities so your wireless clients will have to know the
SSID of your DIR-628 in order to connect to it.
Refer to page 71 for more information regarding wireless security.
Visibility Status:
Wireless Security:
Transmission Rate:
Channel Width:
Enable Auto
Channel Scan:
Wireless Channel:
To Next Page
Loading...
Need help?
General
