D-Link Vonage - Step 3: Set Up Vonage Device with Modem Only

Step 3:
Set up your Vonage Device
(with existing Modem only)
Step 3: Set up your new Vonage Router
7
1. Shut down your computer and unplug your existing
Modem’s power cord.
2. Attach the antenna to your Vonage Device.
3. Unplug the Ethernet cable that connects your
Modem to your Computer. Unplug the cable from
both your Modem and your computer. Leave your
Modem connected to your Internet connection (the
DSL or Cable line from your Internet provider).
5. Connect one end of the blue cable to the Ethernet port
on your Modem. Connect the other end to the blue port
labeled “Internet” on the back of the Vonage Device.
6. Connect one end of the yellow cable to the yellow
port labeled “Ethernet 1” on the back of the Vonage
Device. Connect the other end to the Ethernet port on
your Computer that you unplugged earlier.
4. Wait 10 minutes for your Modem to clear its
memory completely.
6
Existing Modem
Vonage Device
Vonage Device