DAE Controls CO-10 User Manual (English)

To Next Page

Dry Contact Input (zero voltage)

Display mode LCD

Reset mode External / Panel

Display the number of digits 6 digits (font size is 6.7mm height)

Counting input No voltage input, contact input

Reset input No voltage input, contact input

Counting speed 20ms

Installation

CO-10 Installation Guide

1. DIN48 X 24mm

2. Internal battery life ≧ 5 years

3. Error rate ≦ 0.02%

4. LCD display with 6 digits (font size is 6.7mm height) or

8 digits (font size is 8.6mm height)

5. No mechanical wear

6. Max.resistance when terminals are close: ≦ 10km

7. Min resistance when terminals are open: ≧ 500km

8. Minimize signal pulse width ≧ 0.2s

9. Weight: about 60g

10. Hole size 22.2 X 45 mm

11. Can reset on panel or by external terminal

12. Use ambient temperature: -10 ~ 60℃

Electronic Pulse Counter

NOTE

1. UL 2464 24 AWG, shielded twisted pair cable is suggested to connect the Electronic Pulse Counter and Water

Meters.

2. Reset signal should not be connecting for long time in order to avoid wasting internal battery power.

WARNING: A lithium-ion battery inside. Do not make it stay in high pressure or overheat environment.

Need help?

Do you have a question about the DAE Controls CO-10 and is the answer not in the manual?

DAE Controls CO-10 Specifications

General

Make a cutout in the panel according to the specified dimensions for device mounting.

Remove the fastening bracket screw and slide off the fastening bracket from the device.

Insert the electronic pulse counter device into the prepared panel cutout.

Slide the fastening bracket back onto the device and lock it in place with the bracket screw.