1
-
7
IMPORTANT
• The safe working practices list-
ed hereunder concerns only a
few cases of overturning risk.
• The list is therefore NOT com-
prehensive of all possible cas-
es.
To avoid side overturning:
• Adjust the wheels to the maximum
possible track width for the type of
work you are doing.
• Lock both brake pedals together
before driving on road.
• Reduce your speed according to
work conditions. If the tractor is
equipped with a front-end loader,
carry the bucket and load as low as
possible.
• Reduce your speed before making
wide turns. DO NOT let the tractor
jump or bounce on rough terrains.
You could lose control.
• DON'T pull a load too heavy for
your tractor. It could run away on
the down slope or the tractor could
jack-knife around a towed load.
• DON'T brake suddenly. Apply
brakes smoothly and gradually.
• When going down a slope use the
throttle to slow the tractor engine
and use the same gear you would
use to up the slope. Shift into gear
before you start downhill.
• Engage four-wheel drive (if
equipped); this will give greater sta-
bility.
WARNING
•
NEVER disengage the clutch or
attempt to shift gear after you
have started downhill.v
TB2O108A
OM_TC230(CK2620,3520,4020)-EN_USA-01.indd 7OM_TC230(CK2620,3520,4020)-EN_USA-01.indd 7 2023-09-21 오후 5:19:272023-09-21 오후 5:19:27
To Next Page
Loading...
