1
-
16
(1) P.T.O Shaft Cover (2) P.T.O Shaft Cap
WHEN OPERATING THE P.T.O
1. Make sure the tractor is completely
stopped, gears are in neutral and
all moving components have com-
pletely stopped before connecting,
disconnecting, adjusting, clean-
ing or servicing any P.T.O driven
equipment.
2. Keep the P.T.O shaft cover in place
at all times. Replace the P.T.O
shaft cap when the shaft is not in
use.
H23O121A
3. Before installing or using P.T.O
driven equipment, read the man-
ufacturer's manual and review the
safety labels attached to the equip-
ment.
WARNING
•
Before driving an implement
through the PTO, always make
sure that all bystanders are well
away from the tractor.
•
When using the PTO drive with
a stationary tractor, always
make sure that the gears are
in neutral and that the parking
brake is applied.
•
Before starting up any PTO-driv-
en implement hitched to the
three-point linkage, lift the
implement to its full height and
check that at least 1/4 of the
total length of the telescopic
section of the drive shaft is
engaged.
WARNING
•
Ensure that implements and
attachments are properly in-
stalled and that the tractor and
implement PTO RPM ratings
match.
OM_TC230(CK2620,3520,4020)-EN_USA-01.indd 16OM_TC230(CK2620,3520,4020)-EN_USA-01.indd 16 2023-09-21 오후 5:19:302023-09-21 오후 5:19:30
To Next Page
Loading...
