Daedong NS4710 - Page 95

4
DESCRIPTION OF OPERATING SYSTEM
4
-
41
TREAD
(1) Bolt (2) Rim Bolt (3) Disc
H23O4D0a
Whenworkingonaeldwherecropsarelinearlyaligned,thetreadshouldbe
adjusted so that the tires do not cross over the crops.
It is also necessary to widen wheel tread to decrease danger when working on
slopes or hills, or when doing trailer work, etc.
Never operate tractor with a loose rim, wheel, or axle.
• Always tighten nuts or bolts to the specied torque.
• Make sure to frequently check that all these parts are rmly tightened.
• Make sure to perform inspection daily.
WARNING
H11O4D2a
(1) Wheel Nut (2) Rim Bolt
(3) Rim (4) Disc
The front and rear axle tread width
are adjustable by changing the in-
stallation of the tire (together with
rim) to the disk, to suit the type or
condition of work. Ref to “TREAD” in
prior page.
WHEEL TORQUE AND DIRECTION
FRONT/REAR WHEEL INSTALLATION PATTERN
te170 (NS4710, NS6010, NS4710H, NS5310H, NS6010H)-���-04.indd 41 2021-03-15 �� 1:54:33