E-20
Washing procedure and program selection (cont.)
NOTE
• All programs are not selectable.
• Use this program WITHOUT load.
• The appropriate cleaning time is one time per a month.
1
Press the Power button.
• The LED shows only ‘---’ signal.
2
Select the ‘Tub Clean’ program using program selection dial.
• ‘Soak’ and spin ‘400’ rpm and ‘Cold’ water temperature.
3
Press Start/Pause button.
• The washer will be operated with locking Door and supplying water.
* TUB CLEAN PROGRAM
DWC-L1011(영).indd 20 2014-10-02 오후 5:52:21
To Next Page
Loading...
