Methods of exchanging main parts
6) Install the heater covers (upper and lower)
on a new glass tube heater. (Make the
cover with holes the lower one)
7) Place the glass tube heater lead wire
shown as below and fasten the shaded
area with type.
8) Fin insert the lead wire connection
terminals. (Same colored lead wires)
9) Set the evaporator on normal position and
secure the fastening screws.
-8-
Heater Cover
(Top)
Heater Cover
(Bottom)
Frontside
AL tape
Lead wire
Glass tube heater
To Next Page
Loading...
