Daewoo BM090 - Page 20

18
High beam switch
When the head lamps are on, pulling
the lever down lights up not only the
head lamps with high beam but also
the high beam indicator lamp. When
pulling it up, head lamps with low
beam are on.
Passing lamp switch
To light up passing lamps at any
time, pull up the lever towards the
steering wheel.
The lever will return to the OFF posi-
tion when released.
Lamp switch(turn type)
Lamp switch operates in two stages
as follows :
1st stage : tail lamp, license plate
lamp, instrument panel
lamp, clearance lamp
2nd stage : tail lamp, license plate
lamp, instrument panel
lamp, clearance lamp,
head lamp, cornering
lamp(simultaneously with
turn signal lamp “ON”)
Windshield wiper switch
The windshield wiper switch has 3
positions to control the windshield
wiper.
1. OFF ˞ Off
2. INT ˞ Intermittent wipe
3. LO ˞ Continuous wipe, slow speed
4. HI ˞ Continuous wipe, fast speed
high beam
(passing)
high beam
low beam
2nd stage
1st stage
OFF
1
2
3
4
Do not operate the wipers when the
windshield remains dry. They may
scratch the windshield glass. Do not
operate the wipers if they are cov-
ered with snow or ice as this may
damage the wiper system.
NOTICE