Daewoo DAGFS Series - Page 24

23
6. DIGITAL PANEL
KEY FUNCTION DESCRIPTION
CONTROLLER DIMENSION
PARAMETER EDITING
After controller powered on,press to enter ito the parameters setting menu,the menu item
as shown:
1) Press @ key to enter the menu interface after controller started,choose 1. (See Fig 1 );
2) Press ID key to enter parameter configuration password confirm interface (See Fig 2);
When 1234 is put, part of the parameters can be set; when 0318 is input, all the parameters
can be set;
3) Press e or 8 key to increase or decrease values;Press ID key to shift cursor and
confirm setting;
4) If password is correct.enter into parameter interace; Press e key or 8 key to choose