Daewoo DBU-51 - Recording; CD;MP3 Operation; Program Mode

ENG
16
RECORDING
1. Press the “STOP / EJECT” button to open the cassette door and insert a blank tape.
2. Select the source you want to record.
To record from radio - Set the “FUNCTION” selector to “RADIO” mode and adjust the desired
station. To record from CD / MP3 - Place a disc on the CD compartment. Set the “FUNCTION”
selector to “CD / MP3 / USB” mode and select the desired track.
To record from USB - Plug or slot in USB device to the port. (Make sure no disc on disc tray. )
Set the “FUNCTION” selector to “CD / MP3 / USB” mode and select the desired track.
3. Press the “RECORD” button together with the “PLAY” button to start recording.
4. Press the “STOP / EJECT” button when  nished.
CD / MP3 OPERATION
GENERAL OPERATION
PLAY / PAUSE

I I
I I Press to start playing CD / MP3 disc.
Press again to stop playing CD / MP3 operation temporarily. Press again to
resume playback.
SKIP +

I
I & Press to go to the next track or back to the previous track.
SKIP -
I

Press and hold while playing until you  nd the point of the sound.
STOP  Press to stop all CD / MP3 operation.
PLAYBACK
1. Set the “FUNCTION” selector to “CD / MP3 / USB” mode.
2. Open the CD door and place a CD / MP3 disc with the label up on the CD compartment.
3. Close the CD door.
4. Focus search is performed if disc is inside. Total number of tracks is read and appears on
the display.
5. Playback will start automatically from the  rst track.
6. Adjust the “VOLUME” control to the desired level.
7. Press the “PLAY / PAUSE” button again when you want to stop playback temporarily.
8. Press the “STOP” button when  nished.
CD / MP3 OPERATION
GENERAL OPERATION
Up to 20 tracks fo CD disc, 99 tracks of MP3 disc can be programmed for disc play in any
order. Be sure to press the “STOP” button before use.
1. Press the “MODE” button, the display will show “P01” and  ash.
2. Select desired track by using the “SKIP +” or “SKIP -” button. (You may select a desired album
by pressing the “ALBUM” button).
3. Press the “MODE” button again to con rm desired track into the program memory.
4. Repeat step 2 and 3 to enter additional tracks into the program memory.
5. When all the desired tracks have been programmed, press the “PLAY / PAUSE” button to
play the disc in the order you have programmed.
6. Press the “STOP” button twice to terminate programmed playback.