19
4. Slowly pour oil into the oil deposit until the oil level reaches the full
line on the dipstick. Do not overll. Max ll 0.4 L, type SAE 10w30 deter-
gent oil with an API service of SF, Sg, SH, SJ, SL, or higher.)
Note: If you overll the engine, pour some oil out of it as directed in
Changing the Oil.
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling center.
Replacing the Blade
Service Interval: Yearly
Important: You will need a torque wrench to install the
blade properly. If you do not have a torque wrench or are uncomfortable
performing this procedure, contact an Authorized Service Center.
Examine the blade whenever the mower runs out of fuel. If the blade is
damaged or cracked, replace it immediately. If the blade edge is dull or
nicked, have it sharpened or replace it.
WARNING
The blade is sharp. Contact with the blade can result in serious
personal injury.
• Disconnect the spark plug wire.
• Wear heavy gloves when servicing the blade.
7. Install new blade with all mounting hardware; tighten blade bolt by
turning clockwise.
To Next Page
Loading...
