1. To adjust the front wheel cutting height position (g. 2a)
1) Turn the mower upside down.
2) Pull the wheel axle towards the front of the mower.
3) Locate the wheel axle into the desired cutting height adjustment
position.
Note: Make sure that both front right and left wheels are located in the
same cutting height adjustment position.
2. To adjust the rear wheel cutting height position (g. 2b)
1) Turn the mower on its side.
2) Pull the rear wheel axle towards the mower’s catcher ap.
3) Locate the wheel axle into the desire cutting height adjustment posi-
tion.
Note: Make sure that both rear right and left wheel are located in the
same cutting height adjustment position.
3. Cutting height positions (g.2c)
1) 20 mm (Lowest cutting height position)
2) 40 mm
3) 60 mm(Highest cutting height position)
11
To Next Page
Loading...
