12
5. OPERATING
Connect to power supply
WARNING! Before connecting to the mains supply, always
check the switch is in off position. Connect the plug into the RCD
protected power supply.
Starting
On/Off switch g.3)
Caution! Do not start the mower if it is standing in long grass. Press the
safety button (A) of the switch assembly and then pull the switch lever
(B) against the bar. Keep the switch lever held whilst releasing the safe-
ty button. To stop the mower release the switch lever and it automatica-
lly returns to its off position.
Mowing (g.4)
We recommend to use your mower as outlined in this section in order
to achieve optimum results and to reduce the risk of cutting the mains
cable.
• Place the bulk of the mains cable on the close to the starting point.
• Switch the mower on as described above.
• Proceed as shown in g.4
• Move from position 1 to position 2
• Turn right and proceed towards position 3
EN
To Next Page
Loading...
