6.3 HORIZONTAL CENTER
1) Apply a RETMA PATTERN signal.
2) Adjust picture centering with H-CENTER LEFT/RIGHT keys.
7. DATA PRESET(D.P) ADJUSTMENTS
1) Receive a 91 channel.
2) Adjust the SHARPNESS to 0.
3) Enter the service mode using the user remote control by pressing buttons in sequence as follows
R ----> G ---->B ----> MENU
4) Then, D.P OSD in service mode will appear on screen.
5) Press the channel up or down button to enter you wish to adjust.
6) You can control the data by pressing the volume up or down button.
8. FACTORY OUTGOING MODE
1) Press the EX-FACTORY in service mode, then set becomes factory outgoing status.
2) You can see the OSD “outgoing OK!”.
To Next Page
Loading...
