SETTING AUTO IP
In on-hook state, press SET/ST key and then press ▲ key 3 times, LCD will display SET 4 AUTO IP.
Note: This function is unavailable, so the users do not need to set this item.
SETTING DIALING TYPE
In on-hook state, press SET/ST key and then press ▲ key 4 times, LCD will display SET 5 P-T.
Press SET/ST key to confirm, LCD displays TONE, press ▲ or ▼ key to select TONE or PULSE.
The most common dialing mode is TONE which is the factory preset, just in some concrete cases when the
phone is connected to a switchboard or in some countries you will need to change it to PULSE.
SETTING ANTI-DIALING FUNCTION
In on-hook state, press SET/ST key and then press ▲ key 5 times, LCD displays SET 6 ALAR
Press SET/ST key to confirm, LCD displays ALAR OFF, press ▲ or ▼ key to select ON or OFF.
Press SET/ST key to confirm.
When the anti-dialing is set to ON, users who want to dial using an extension (parallel phone) via the same line
will hear a “DI-DI, DI-DI” beep continuously and will not be allowed to make a call.
SETTING LCD CONTRAST LEVEL
In on-hook state, press SET/ST key and then press ▲ key 6 times, LCD displays SET 7 LCD
Press SET/ST key to enter, LCD displays LCD 3, press SET/ST to enter, LCD displays LCD 3, press ▲ or
▼ to select among 1~5 levels.
Press SET/ST key to confirm and exit.
HOLD ON MUSIC
When talking over handset, press HOLD/RING key to enter the hold mode and the hold music is
sent out. In hold mode
Press HOLD/RING key to release hold mode and continue to talk over handset, or
Hang up handset, it enters hands-free hold mode.
When talking at hands-free mode, press HOLD/RING key to enter the hold mode and the hold music
is sent out. In hold mode
Pick up handset to talk over handset, or
Press or HOLD/RING key to quit hold mode and talk at hands-free mode.
SETTING RINGING TONE
There are 8 kinds of ringing tone for selection:
In on-hook state, press HOLD/RING key, LCD display RING 01. Press ▲ or ▼ key to select ring tone.
Besides, you can also press HOLD/RING key repeatedly to select the ringer.
ONE-TOUCH MEMORY
Storing a number into one-touch memory
In on-hook state, pre-dial the desired number or review the incoming or outgoing list for the desired
number to store.
Press SET/ST key, then press M1 or M2 or M3 key to store the number.
Make a call from one-touch memory
In on/off-hook situation, press M1 or M2 or M3 key to dial out the stored number. The telephone will add PABX
code ahead the number if the number is 6-digit or more than 6-digit.
HANDS-FREE VOLUME
In off-hook state, press VOL key continuously to adjust the hands-free volume, there are 2 levels can be select.
To Next Page
Loading...
