Daewoo FR-631ND User Manual

1
• Unstable installation causes vibration and
noise of refrigerator.
• Wooden floor or carpet can be discolored
under the refrigerator.
• Doors look hanged down due to the twist
of refrigerator unless it is leveled.
• More than 10 cm from 3 sides (left, right
and back) is good enough for ventilation.
• Insufficient space causes the noise of
vibration, weakening of refrigerating
power and the waste of electricity.
• Direct sun lays, side heat of stove and gas
range can weaken the refrigerating power.
•
Avoid location by a sink or where moisture
and water can cause rust and corrosion.
• Avoid location where moisture can cause
electrical problems.
• Use hard board or plank on the
concrete/cement floor.
1. Installation Instructions
Where the floor is solid and level Where ventilation is good Where there is little or no heat, moisture
Suitable Installation Place
Grounding is necessary
where
Grounding by using
grounding wire
Grounding by using
short-circuit breaker
Grounding is not necessary
You should not connect the
ground wire to
■ Grounding terminal is the green one connected to the power cord in the back of refrigerator.
Bury copper plate to whitch grounding wire is connected 25 cm deep in the ground.
Short-circuit breaker is a must where the floor is always wet, for example, fish shop,
restaurant kitchen etc.
in case of using side-grounded outlet.
water pipe, gas pipe, telephone line,
lightening-rod.
There can be explosion or fire.
Grounding wire
Side
Grounded
outlet
Grounding
Correct usage of Refrigerator Installation Process
water can splash easily ;
bathroom etc.
there is much moisture ;
basement etc.
any wet and/or watery
places.
Plug in the refrigerator
right after installation.
Set the both
compartments’
temperature to “3” to
perform preparatory run
for 2 or 3 hours.
When the inside is cold
enough, put the foods in.
* See page for
details.
* When the surrounding
temperature is hot in
midsummer, do not
open and shut the doors
too often after
installation.
2
Attatch the height adjustable legs to their holes in the
left and right bottom of refrigerator.
Adjust the height by turning the legs until they touch the floor.
• Let the right adjustable leg touch the floor firmly, while the
left, smoothly.

Daewoo FR-631ND Specifications

General

Brand	Daewoo
Model	FR-631ND
Category	Refrigerator
Language	English

Summary

1. Installation Instructions

Suitable Installation Place

Guidance on selecting an appropriate location for the refrigerator, considering floor stability, ventilation, and environmental factors.

Grounding Requirements

Information on the necessity and methods of grounding the refrigerator for electrical safety.

Correct Usage After Installation

Installation Process Steps

2. Safety Instructions

Ventilation Safety

Ensuring adequate ventilation to prevent overheating, noise, and reduced cooling efficiency.

Exclusive Power Outlet Usage

Recommendation to use a dedicated power outlet for the refrigerator to prevent fire hazards.

Plug Cleaning Precautions

Emergency Response Procedures

Actions to take when smelling burning, using sprays, or encountering loose plugs, and food poisoning risks.

Moisture and Water Hazards

Caution against installing the refrigerator in wet areas to prevent short circuits or fires.

Heavy Object Placement Warning

Unplugging and Grounding Safety

Door Handling and Power Failure

Moving, Carrying, and Installation Safety

Guidelines for safely moving, carrying, and ensuring stable installation of the refrigerator.

Operational Safety Precautions

Touch and Electrical Hazards

Warnings about touching cold surfaces and electrical risks when cleaning under the unit.

3. Troubleshooting Common Issues

Fresh Food Freezing

Refrigerator Not Cooling Properly

Insufficient Cooling Causes

Refrigerator Noise Issues

5. Temperature Control Panel

Temperature Control Modes

Explanation of temperature settings and indicators for different cooling modes.

Silent Operation Mode

How the refrigerator adjusts to silent operation based on ambient light.

Sleeping Mode Functionality

Instructions for activating sleeping mode for reduced operation before bedtime.

Speed Operation Mode

Automatic activation of speed operation for heavy loads or frequent door openings.

6. Care and Cleaning

Exterior Cleaning

Interior Cleaning Guidelines