26
INPUT CONTROL OBJECT
CONTENTS REMARKS
Temperature Control Buttons
4-10. Filter information & Function to adjust the amount of water
( Dispenser Models Only )
88 Display Custom LED
Filter information
1. Filter Exchange Information : Record a real-time from the point of power input.
- The filter is normal for 6 months after the first installation.
- When the time comes to change or reset, press the WATER FILTER RESET button for 5 seconds.
2. Function of display of filter change time.
[step1] Press CRUSHED ICE button 5 times while pushing WATER button at the same time.
[step2] Press SUPER FREEZER button 5 times while pushing FREEZER SET button.
[step3] Press FREEZER SET button 6 times successively. (Fi-Lt is display)
[step4] Remaining time is display if DISPENSER button press.
( ex, 40 12 means that 4012minutes remains until the filter exchange. )
[END] Push RESET WATER FILTER or it is reset after 4 minutes.
Adjust the amount of Water
[step1] Press CRUSHED ICE button 5 times while pushing WATER button at the same time
.
[step2] Press SUPER FREEZER button 5 times while pushing FREEZER SET button.
[step3] Press FREEZER SET button 5 times successively. (P100 is display.)
- Initial setting P100 means 86cc water supply.
[step4] Adjust the amount of water
- If the amount is less than P100, press SUPER REFRIGERATOR button.
: P101 ( 87cc ), P102 ( 88cc ), P103 ( 89cc )…
- If the amount is more than P100, press REFRIGERATOR SET button.
: P99 ( 85cc ), P98 ( 84cc ), P97 ( 83cc )…
[END] Push RESET WATER FILTER or it is reset after 4 minutes.
To Next Page
Loading...
