43
CLEANING THE FILTER PRECAUTIONS FOR SAFE USE
This vacuum cleaner should only be used for normal dry household dust and dirt.
The manufacturer cannot be responsible for any damage caused by use or operation of the cleaner
contrary to these instructions.
If the cleaner is wrongly operated for a purpose other than that for which it is intended. no liability can
be accepted for any possible damage.
CHANGING THE DUSTBAG
• Switch off.
• Press the clamp position of the
air outlet cover to discharge the
air outlet cover forclean up or a
new replacement.
•
Separate the filter from the
filter case and shake the
dust out of the filter.
•
Do not vacuum areas which contain moisture
or water and inflammable matter, needles,
pins, razor blades, matches, cigarette-ends,
etc., since they may damage the cleaner or
dust bag or cause a fire.
•
When rewinding the power cord, hold the
plug body before pressing the cord rewind
button to prevent whipping.
•
Do not pull the power cord beyond the
specified length.
•
Make sure a dust bag and a motor protection
filter are always inserted.
•
This product provided with a cable which, if
damaged must be replaced by a repair shop
authorized by the manufacturer since special
tools are required.
•
Switch off and open the
cover.
•
Take the dust bag holder
with dust bag out from the
dust compartment
• Shake the dust out of the
filter.
EXHAUST FILTER
MOTOR PROTECTION
FILTER
•
Switch off and open the
cover.
•
Take the dust bag holder
with dust bag out from the
dust compartment.
•
Insert the new dust bag into
the dust bag holder properly
as shown in picture.
Note:
If no dustbag has been
placed into the dustbag holder,
the cover cannot be closed.
To Next Page
Loading...
Need help?
General
