Once all parts are thoroughly dry, reassemble
the cylinder.
Place the HEPA lter back into the lter
assembly and re-attach the lter assembly to
the cylinder lid.
Ensure all parts click back into place by
aligning the arrow on the lter assembly with
the open padlock symbol on the lid then
turning in the direction of the closed padlock
Rectangular HEPA lter
To access the rectangular HEPA lter, remove the cylinder as described.
The rectangular lter is located in the body of the vacuum cleaner behind
the cylinder.
To remove the lter from the vacuum
cleaner body, press down on the catch
at the top of the lter and pull the lter
towards you.
Tap the lter over a dustbin to remove
any excess dust and debris then rinse
under warm water until the water runs
clear.
Leave to dry for 24 hours before
retting to the vacuum cleaner.
Tornado F1 Upright Vacuum
FLR00049
User Manual
To Next Page
Loading...
Need help?
General
